Updating kernel ps3

This is a huge release for us and the culmination of over a year of work addressing customer requests.The run-time is still shared with Telemetry 1.x, so migration should be a snap!

The Kinect 2 was originally manditory to be plugged in order for the console to function.

Note: EOL cameras or cameras that will soon be EOL will not be supported.

Installing a Custom Firmware on your PSP 2000 has never been so easy.

In order to install Pro CFW on your PSP, you will need to first update your PSP to the 6.60 Sony firmware (which, at the time of this writing, is the latest firmware released by Sony), if that’s not already the case.

Boot ROM 1.20 Booting from NAND flash Step 1: First phase of PEX-PIPE Configuration Step 2: Configure the desire PIN_PHY_GEN Step 3 QSGMII enable Step 4: Configure SERDES MUXes Step 5: Activate the RX High Impedance Mode Step 6: [PEX-Only] PEX-Main configuration (X4 or X1) Step 6.2: [PEX-Only] PCI Express Link Capabilities Step 7: [PEX-X4 Only] To create PEX-Link Steps 7,8,9,10 and 11 Steps 12: [PEX-Only] Last phase of PEX-PIPE Configuration Steps 13: Wait 15ms before checking results Steps 14: [PEX-Only] In order to configure Steps 15: [PEX-Only] In order to configure Steps 16: [PEX-Only] Training Enablestep 17: max_if= 0x7 step 17: PEX0 pex Unit= 0 ** Link is Gen1, check the EP capability -- DC12 Gen2 client! Status Reg(0x0004DA64) = 0x00000001 step 17: PEX4 pex Unit= 1 PEX4 : Detected No Link.